Installation Time: 2 Hours
Dealer Pricing available: Email us for dealer/wholesale pricing
||Parts included in Package:
| Drill Motor
|| Light Bar
| 1 1/2" Hole Saw
|| 4 - Washer 5/16
|| 4 - 5/16 x 1 3/4" Hex Head Bolt
| Eye Protection
|| 2 - Light Blue Electrical Connectors
| 1/8" Drill Bit (Pilot for 1 1/2" Open End Wrench
|| 2 - Dark Blue Electrical Connectors
| 1/2" Open End Wrench
|| 2 - T-Brackets
| Wire Crimper
| Test Light
Cut out templates
Tape templates on top of rear panels as directed on templates
Remove rear quarter trim panel center section that covers the speakers (one on each side)
Use a drill motor and 1 1/2" hole saw to put holes in the tops of both panels and steel substrate below panel.
Warning...Before drilling, cover speakers, seatbelt and seatbelt retractors. Hot metal shavings may damage.
Slide T- Bracket (nuts rearward) into the top of the left-hand and right-hand Black Brackets that are immediately in the front of the convenience top gear. The T-Bracket "T"s will hold bar in place.
Insert Light Bar
Bolt Light Bar to vehicle using (4) 5/16 washers and (4) 5/16 x 1 3/4" bolts supplied in kit.
Wire Light Bar brake light to vehicle at the harness located below driver side rear speaker. Locate the ground and positive wires (green with orange stripe) that operate the third light on the trunk lid and verify with test light. Tie in using connectors supplied in kit.
Back to the Pricing Page